BEHR PREMIUM PLUS ULTRA® is a paint and primer in one coating that will change the way you paint. This exciting product features NANOGUARD® technology with an extra-protective shell that offers a STAYS LOOKING NEW LONGER® finish for ultimate durability. It is ideal for use in every room including high traffic areas and on surfaces where moisture, mildew, or fungus growth may be a problem. This sophisticated color palette delivers COLORS THAT PERFORM BEAUTIFULLY® with superior stain removal.

Tech Data Sheet HERE

Tintable Bases

  • Deep Base No. 1753 - MSDS
  • Ultra Pure White® No. 1750 - MSDS
  • Medium Base No. 1754 - MSDS


Properly prepared coated and uncoated Interior surfaces. Ideal for Family Rooms, Living Rooms, Dining Rooms, Bedrooms, Hallways and Ceilings.


  • All surfaces should be properly prepared and cleaned. Remove loose paint, wash off dirt and grease with detergent, rinse and allow to dry.
  • Remove mildew stains with a mildew stain remover. Scuff sand glossy surfaces and repair imperfections. Remove all dust with a damp cloth, allow to dry.
  • Allow new stucco, plaster and masonry to cure for 30 days before painting.
  • Use BEHR PREMIUM PLUS ULTRA® paint as a primer for properly prepared uncoated or painted interior surfaces. Lock in stains with BEHR PREMIUM PLUS ULTRA as a spot primer.
  • For heavy stains, test for stain bleed-through by applying BEHR PREMIUM PLUS ULTRA as a topcoat to a small section. If the stain bleeds through the topcoat, spot prime another coat to the stained area and test again before topcoating. If bleeding continues, a longer dry time is needed before top coating.
  • For drastic color changes or when applying deep colors denoted with a dagger (†) on the color chip, apply a tinted primer coat of BEHR PREMIUM PLUS ULTRA if needed.

  • Apply when air and surface temperatures are between 50-90°F (10-32°C).
  • Stir paint occasionally. Intermix containers of same product to ensure color and sheen uniformity.
  • Use a high quality 3/8-1/2" nap roller cover, nylon/polyester brush or an airless sprayer (.015-.019" spray tip, 60 mesh filter).
  • Do not thin if using a roller or brush; however, if using a sprayer and thinning is required, thin with water at a rate of no more than 1/2 pint per gallon.
  • Certain colors may require more than one coat for complete hide.
  • Darker colors may require additional dry time between coats. Cooler temperatures or higher humidity may prolong drying time.
  • After 4 weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent. Dry paint film is mildew resistant.

  • For disposal of empty containers, unused paint and soiled rags, contact your household refuse collection service.

  • Visit for painting tips, expert project advice and the perfect color coordination with COLORSMART BY BEHR™.


    If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to

    Behr Waterproofing Wood Finish contains a mildewcide and will protect wood from water damage for 2-4 years. This product from Behr Paints and Stains can be applied to damp wood in temperatures as low as 40°C. Product safety information is readily available from